Adjustable heavy duty foot as a common equipment, widely used in various occasions, its biggest feature is that it can be adjusted in height and level according to the actual demand. So, how to adjust it correctly? Next, let’s walk into the world of adjustable heavy duty feet together.
First, adjust the height and level
1. Adjust the height of the screw leg
First, you will need to unscrew the hexagonal set nut on the lower end of the threaded rod using a wrench or rugby wrench. Next, rotate the threaded rod so that the distance between the sole of the foot and the ground reaches the desired height. Finally, tighten the hexagonal fixing nut on the lower end of the threaded rod to complete the height adjustment.
2. Adjusting the height of the adjustment pad
Besides the screwed leg, the adjustment pad is also an important part. Unscrew the hexagonal fixing nut at the upper end of the threaded rod, and then pivot the adjusting pad upward or downward until it reaches the desired height. Finally, tighten the hexagonal fixing nut on the top end of the threaded rod.
3. Leveling
Place the installed adjustable heavy-duty foot in the position to be adjusted and use a level or leveling tape to check if it is level. If it is not level, you can use the adjusting pad to fine-tune it until the foot is perfectly level.
Precautions and application tips
Avoid violent stepping or impact during use and adjustment to avoid damage to the footing.
Always make sure that the load does not exceed the carrying range of the foot.
Before installation, always read the instructions carefully to ensure that each step is correct.
Perform regular maintenance such as cleaning the threaded rod and checking the tightness of the hexagonal fixing nut.
III. Common Problems and Solutions
If the Adjustable Heavy Duty Foot is not adjustable, there may be a problem between the threaded rod and the hex retaining nut. Check that they are fully separated and replace the damaged part if necessary.
If the foot is unstable, check that the adjustment pads are correctly fitted to ensure that they are in full contact with the floor.
If the noise is excessive after use, the threaded rod surface may be rough or in need of lubrication. Try cleaning and lubrication treatments and if the problem persists, it is advisable to seek the help of a maintenance professional.
Adjustable heavy-duty floor feet may seem simple, but proper use and adjustment ensures maximum performance. We hope this article has provided you with a valuable reference for adjusting your feet!
Post time: Apr-24-2024